Advice On How To Pass A Roof Inspection Of Your Home

If you have minor roof leaks, there is no need to hire a professional roofing expert to mend them because you can always fix them on your own. Here is the best advice from http://roofingrenonv.net/ on how to repair a roof, regardless of the size and material.

1. Repairing Shingles

If you have a flat roof, it’s easier to identify any problems with the shingles near the area where the water is leaking into your house. Remember that the source of the leak might be a little farther away from where the leak was actually spotted. If you have a slanted roof, inspect areas higher than where the leak was detected. Inspect your attic for water stains, mold or black marks. Run a hose on your roof and let another person alert you when there’s a leak inside the house.

Once you have identified the leak, look for missing, damaged or curled shingles since they are the source of the leak. Look for any roofing tacks that might be exposed too. Straighten out the curled shingles by softening the edge with heat from a blow-dryer. Avoid using an open flame since they are flammable and the excess heat will ruin the shingle. Reattach them once they are straightened with asphalt roof cement. Also, if there are any damaged shingles, you should replace them to avoid further leaks into your house.

2. Repairing Damaged Shakes

Get a chisel and hammer then split the damaged shakes. Remove the pieces by placing the chisel under the damaged unit. Remove the ends of any pried out nails using a hacksaw. You can also choose to work around the nails if you can’t saw without damaging the remaining good shakes. Cut off new shakes and slide them into place then seal using a caulking compound for the best results.

3. Roll Roofing

Start by inspecting for blisters or cracks present in the roofing material. If there are any, you should mend them. Use a utility knife to cut through the middle of the blister but avoid cutting the substrate found underneath it. Soak up or squeeze out any water found inside to make sure the area is completely dry. Spread some roofing cement on the loose roofing material and press it down. Once you have repaired the blister, you should hammer some galvanized roofing nails to it then cover the whole area with more roofing cement, including the nails for the best results.

The first step of repairing a roof is identifying the leaks present. Make sure you check thoroughly to avoid missing out any leaks that might do more harm to your roof even after you have done the necessary repair. Check the attic, the shingles and also your ceiling for any mold or water stains that might help you trace the source of the leak effortlessly. Next, you should use the right roofing repair materials to replace the damaged or broken areas. If you have some extra shingles, you can always replace the missing ones to avoid further leaks to your property.